Artist Proof version of #87824 Tinker Bell is making magic happen with this framed pin. The frame edge is purple glitter with silver stars and squiggles around three of its corners. Tinker Bell is on the upper left corner of the frame suspended in flight with her wand in her left hand extended into the picture frame. Her wing tips extend above the top edge of the pin. The picture is a B&W sketch of Sleeping Beauty's castle covered with clear plastic, as if it was the glass in a framed picture. This pin is double in thickness and can almost be considered a pin on pin. At the top of the pin is a baby blue colored tab with the DLR logo in purple letters; DISNEYLAND ©RESORT. When you pull up on this tab a card slides out of the top of the pin and the B&W sketch disappears leaving a white blank inside the picture frame. The card that pulls up has a full color illustration of Sleeping Beauty's castle at night with three fireworks bursts above it. The back of the pin has a silver Mickey icon waffle pattern with two horizontal pin posts near the top mounted on 1/4" raised pillars. There are four rivets, one in each corner, holding the front and back halves of the pin together. Just below the middle of the posts is the Official 2011 Pin Trading logo. Below that is a swing-out easel stand, attached with two rivets, so that the pin can stand like a picture frame on a table. To the right of the stand is a box with ©DISNEY, MADE IN CHINA. The black backer card has several stars and the words "It's Magic" in the upper right "ear" tab. Below that near the top right corner of the pin (when it is mounted on the card) is an arrow pointing upward and the words "PULL UP," referring to the pin's tab that pulls out the card that reveals the color picture of the castle. The pin measures 1 3/8" wide and 1 7/8" tall to the top of the tab. AP Stamp on back under Disney box.